Specifies the included angle between objects, based on the center point of the array and the base points of the arrayed objects. Enter a positive number for a counterclockwise rotation or a negative number for a clockwise rotation.Īngle between items (+=ccw, -=cw) (+=ccw, -=cw) Specifies the included angle between the base points of the first and last arrayed objects. If you do not enter a value, the array is based on the Angle to Fill and Angle Between Items values.Īngle to fill (+=ccw, -=cw) (+=ccw, -=cw) Specifies the total number of items to be arrayed around the center point.

Specifies a new reference (base) point relative to the selected objects that will remain at a constant distance from the center point of the array as the objects are arrayed. Specifies the central location for the array. The prompt values you enter determine whether the array configuration is based on the number of items or the angle that is filled by the arrayed items. You can also make the selection set into a block and replicate it. Removing an object from the selection set and adding it back forces that object to be the last object selected. If you defined the selection set by using window or crossing selection, the last object in the selection set is arbitrary. In a polar array, the reference point of the last object in the selection set is used for all objects. The SNAPANG system variable stores the snap rotation angle. Use the Rotate option of the SNAP command to change the angle and creates a rotated array. This angle is normally 0, so the rows and columns are orthogonal with respect to the X and Y drawing axes.

Rectangular arrays are constructed along a baseline defined by the current snap rotation.

To add columns to the left, specify a negative value for the distance between columns. To specify the distance between rows and columns at the same time, specify two sets of coordinates or drawing locations that represent the opposite corners of a rectangle. To add rows downward, specify a negative value for the distance between rows.

Specifies the distance between rows, including the length of the object to be arrayed. If you specify one row, you must specify more than one column and vice versa.ĭistance between rows or specify unit cell Specifies the number of rows using a nonzero integer. The selected object, or cornerstone element, is assumed to be in the lower-left corner, and generates the array up and to the right.

How to use autocad 2019